Quote:
Originally Posted by LostViking  Hi, I'll help as much as I can. You can drop my Pdaparts.com and look up their replacement screens/digitizer. They show step by step directions for the replacement. At first glance I'm not really sure what the problem is with your system. Make sure the connector was latched closed when you inserted the ribbon cable from the new digitizer. Make sure you didn't put it on upside down. The metal contacts are only on one side of the ribbon cable. I'm not looking at one right now so I'm not sure if that is possible. Check. The glue doesn't matter, it just holds the digitizer is place. The digitizer is a completely separate part and does not matter if there are LCD problems so don't be concerned with that.
Other than that I can't see a reason why, unless the digitizer you purchased was bad. It does happen. There is a fragile bond between the "contacts" on the edge of the glass and the ribbon. It does not take too much to cause this to fail and if even one of the four connections fails, the digitizer is trash. You can probably by the digitizer from pdaparts.com. I think they also sell the complete display assemblies. For the 650 they were pretty cheap too. For some reason the 680 ones are much higher.
Give it a shot.
By the way, I sent my Treo back. I don't use one anymore and I'm not coming by this site anymore. They keep sending me emails so I guess asking nicely didn't work. I'll give them a SHOUT this time.
Anyway regards. |
Hi Lost Viking: thank you for taking the time to response my question,really appreciate it and I'll give a shot to make it work ;again thanks for all your info and hopefully make it work .
THANKS!!!!