Results 1 to 4 of 4
This is a discussion on Speaker not working on 700P within the Treo Smartphones forums; The speaker (the one used when holding the phone to your head) on my Verizon 700P has suddenly stopped working. ...
  1. 04-02-2008, 11:04 AM #1
    CM1613
    CM1613 is offline
    Join Date
    Nov 2007
    Posts
    10
    Downloads
    0
    Uploads
    0

    Default Speaker not working on 700P

    The speaker (the one used when holding the phone to your head) on my Verizon 700P has suddenly stopped working. I can switch to speaker phone to hear the other party but I can not use the phone in a traditional way. Has anyone else experienced this and is it a hardware or software issue. I have the following running on my phone:
    Butler
    Phone Technician
    Call Rec
    TCPMP

    None of which are recent installs that would lead me to suspect that they are the issue.
    Reply With Quote Reply With Quote
  2. 04-03-2008, 12:30 AM #2
    benjie
    benjie is offline
    Join Date
    Aug 2006
    Location
    In the middle of nowhere.
    Posts
    3,027
    Downloads
    0
    Uploads
    0

    Default

    Did you use a plug-in headset?

    Ben
    Honolulu - 2,500 miles west of somewhere in the middle of nowhere, the land of Shakes. Kyoceria 6135, Treo 300, 600, 650, 700p, 700w, Centro & 800W, Touch Pro plus 3 other WM phones...
    Reply With Quote Reply With Quote
  3. 04-03-2008, 12:54 AM #3
    CM1613
    CM1613 is offline
    Join Date
    Nov 2007
    Posts
    10
    Downloads
    0
    Uploads
    0

    Default

    No but I intend to until I can figure out how to fix it.
    Reply With Quote Reply With Quote
  4. 04-03-2008, 05:29 PM #4
    CM1613
    CM1613 is offline
    Join Date
    Nov 2007
    Posts
    10
    Downloads
    0
    Uploads
    0

    Default

    Found a possible fix. Haven't tried it yet (I don't have a #5 troque driver). Will update the outcome after I try to fix it. WISH ME LUCK !!:laugh3:

    YOU NEED TORQUE #5 SCEWDRIVER.

    1. TAKE OUT SIM TRAY.

    2. REMOVE 4 SCREWS ON BACK, TAKE OUT ANTENNA.

    3. STARTING ON THE TOP AND SIDE, PRAY OPEN THE CASE WITH YOUR FINGERS
    LEFT AND RIGHT SIDE, WORK DOWN YOUR WAY CAREFULLY.

    4. TAKE BACK OFF, REMOVE 2 MORE SCREWS HOLDING THE MAIN PCB BOARD AND
    FLIP IT TO THE RIGHT SIDE.

    5. YOU NOW SEE THE EARPIECE WITH 2 SPRINGS, HOLD IT DOWN AND STRETCH
    EACH SPRING ABOUT 1/8 (2-3MM) OF AN INCH WITH A TOUTHPICK OR SMALL
    PLIERS. REASSEMPLE.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules